I recently installed Kubuntu 9.04 + Nvidia driver 180.44 on my Dell Latitude E6400 (1440x900) with NVIDIA Quadro NVS 160M. I have the G2410 1920x1080 external monitor. The monitor is connected via VGA. I am very pleased to have the monitor running at full resolution. However, the settings don't stay intact after rebooting.
If I have the monitor connected and turn on the the laptop, only the laptop screen is active. Then, I press Fn + F8 twice to switch to the external monitor which is always reset to 1440x900. After logging in I open Nvidia settings and switch the external monitor resolution to auto. There is a warning about Meta modes and I do auto fix. Then compositing is disabled, so I open system settings, turn off then turn back on desktop effect. Also, if I want to switch back to the laptop display, it stays stuck at 1920x1080 on the laptop.
Is there any way to set this up so it is automatically detected when the external monitor is plugged in and runs at the correct resolution? With my old M1330 and Intel X3100 graphics card, it would do this and was very convenient switching back and forth between the laptop display and external monitor.