Linux.com

Home Linux Community Forums Hardware Networking Configuration for ethernet wired Engenius 3500

Configuration for ethernet wired Engenius 3500

Link to this post 02 Apr 11

The physical setup is this: our marina provides wireless. On the boat we have a Rootena connected to an Engenius 3500 acting as an access point. The Engenius is cabled to the ethernet port. Using "Network Connections" (Ubuntu 10.04) I set the "IPV4" to Manual, Address to 192.168.1.21, Netmask to 255.255.255.0. Gateway to 192.168.1.1. "Apply" & authorize. I also turn off "Wireless" at the panel icon for Network Connections.

In the browser I enter 192.168.1.1 and get the software of the Engenius 3500. Clear in with name and password. Set the Engenius to be a access point, find the signals, select the desired signal, enter the WEP password and save.

Returning to Network Connections I return the computer to Automatic DHCP. The connection symbol whirls for quite a long time then the screen announces "wired network disconnected - you are now offline"

What's really maddening is that this thing worked for me at one point. It was blind luck that I found the correct combination of settings and procedures. After working on this off and on for about three weeks I've decided to ask for help. So if you can, I'll appreciated it. Thank you, Doug

Link to this post 02 Apr 11

My guess is that either your AP or the marina's router is not forwarding ARP packets properly. What are the contents of your /etc/resolv.conf file?

Link to this post 02 Apr 11

Rubberman,

Nope. I can get the net through my laptop's internal antenna.
Thanks, Doug

Who we are ?

The Linux Foundation is a non-profit consortium dedicated to the growth of Linux.

More About the foundation...

Frequent Questions

Join / Linux Training / Board