February 24, 2016

"clean" doesn't clean up

Following up on my other post I want to note that the provided scripts in the devstack distribution aren't of much help. I tried to "unstack.sh" followed by "clean.sh" but the configuration is still far from clean. For instance the eth2 interface no longer has an IPv4 address, but there's a br100 (bridge?) interface with severall IPv4 addresses:

4: eth2: mtu 1500 qdisc pfifo_fast master br100 state UP group default qlen 1000
link/ether bc:76:4e:06:31:e8 brd ff:ff:ff:ff:ff:ff
inet6 fe80::be76:4eff:fe06:31e8/64 scope link
valid_lft forever preferred_lft forever
5: virbr0: mtu 1500 qdisc noqueue state DOWN group default
link/ether ca:76:f7:45:ce:1f brd ff:ff:ff:ff:ff:ff
inet 192.168.122.1/24 brd 192.168.122.255 scope global virbr0
valid_lft forever preferred_lft forever
6: br100: mtu 1500 qdisc noqueue state UP group default
link/ether bc:76:4e:06:31:e8 brd ff:ff:ff:ff:ff:ff
inet 10.10.129.255/20 brd 10.10.143.255 scope global br100
valid_lft forever preferred_lft forever
inet 192.168.97.1/24 brd 192.168.97.255 scope global br100
valid_lft forever preferred_lft forever
inet 192.168.100.129/32 scope global br100
valid_lft forever preferred_lft forever
inet6 fe80::d46d:cdff:fe71:4326/64 scope link
valid_lft forever preferred_lft forever

So I guess there's no other option than to restart the whole lab environment.

Click Here!