Manpage of HD
HDSection: Linux Programmer's Manual (4)
NAMEhd - MFM/IDE hard disk devices
DESCRIPTIONThe hd*devices are block devices to access MFM/IDE hard disk drives in raw mode. The master drive on the primary IDE controller (major device number 3) is hda; the slave drive is hdb. The master drive of the second controller (major device number 22) is hdcand the slave is hdd.
General IDE block device names have the form hdX, or hdXP, where Xis a letter denoting the physical drive, and Pis a number denoting the partition on that physical drive. The first form, hdX, is used to address the whole drive. Partition numbers are assigned in the order the partitions are discovered, and only nonempty, noended partitions get a number. However, partition numbers 1-4 are given to the four partitions described in the MBR (the "primary" partitions), regardless of whether they are unused or extended. Thus, the first logical partition will be hdX5. Both DOS-type partitioning and BSD-disklabel partitioning are supported. You can have at most 63 partitions on an IDE disk.
For example, /dev/hdarefers to all of the first IDE drive in the system; and /dev/hdb3refers to the third DOS "primary" partition on the second one.
They are typically created by:
mknod -m 660 /dev/hda b 3 0
mknod -m 660 /dev/hda1 b 3 1
mknod -m 660 /dev/hda2 b 3 2
mknod -m 660 /dev/hda8 b 3 8
mknod -m 660 /dev/hdb b 3 64
mknod -m 660 /dev/hdb1 b 3 65
mknod -m 660 /dev/hdb2 b 3 66
mknod -m 660 /dev/hdb8 b 3 72
chown root:disk /dev/hd*
SEE ALSOchown(1), mknod(1), sd(4), mount(8)
This document was created by man2html, using the manual pages.
Time: 16:30:28 GMT, December 12, 2016 Click Here!